Yamaha WR450Fv2008, Руководство по эксплуатации для владельца

Страница: 102 / 220

5-8
CARBURETOR
CHECKING THE ACCELERATOR
PUMP
1. Inspect:
•
Diaphragm (accelerator pump)
"1"
•
Spring (accelerator pump) "2"
• Accelerator pump cover "3"
•
O-ring "4"
• Push rod "5"
Tears (diaphragm)/damage
→
Replace.
Dirt
→
Clean.
2. Inspect:
•
Throttle shaft "1"
• Spring "2"
•
Lever 1 "3"
• Spring 1 "4"
•
Lever 2 "5"
• Spring 2 "6"
Dirt
→
Clean.
CHECKING THE AIR CUT VALVE
1. Inspect:
• Diaphragm (air cut valve) "1"
•
Spring (air cut valve) "2"
• Air cut valve cover "3"
•
O-ring "4"
Tears (diaphragm)/damage
→
Replace.
ASSEMBLING THE CARBURETOR
1. Install:
• Cold starter plunger "1"
2. Install:
•
Pilot air jet "1"
3. Install:
•
Spring 1 "1"
• Lever 1 "2"
To lever 2 "3".
Make sure the spring 1 fits on the
stopper "a" of the lever 2.
4. Install:
• Spring 2 "1"
To lever 2 "2".
5. Install:
• Push rod link lever assembly "1"
Make sure the stopper "a" of the
spring 2 fits into the recess "b" in the
carburetor.
6. Install:
• Washer "1"
•
Circlip "2"
7. Install:
•
Spring "1"
To throttle shaft "2".
Install the bigger hook "a" of the
spring fits on the stopper "b" of the
throttle shaft pulley.
8. Install:
• Throttle shaft assembly "1"
•
Washer (metal) "2"
• Washer (resin) "3"
•
Valve lever "4"
•
Apply the fluorochemical grease on
the bearings.
•
Fit the projection "a" on the throttle
shaft assembly into the slot "b" in
the throttle position sensor.
• Make sure the stopper "c" of the
spring fits into the recess in the car-
buretor.
•
Turn the throttle shaft assembly left
while holding down the lever 1 "5"
and fit the throttle stop screw tip "d"
to the stopper "e" of the throttle
shaft assembly pulley.