Yamaha WOLVERINE YFM45FXV, Дополнительное руководство по обслуживанию, Страница: 29 / 112

– 22 –
CHK
ADJ
GENERAL MAINTENANCE AND LUBRICATION CHART
(For CDN)
GENERAL MAINTENANCE AND LUBRICATION CHART (For CDN)
NOTE:
• Recommended brake fluid: DOT 4
• Brake fluid replacement:
• When disassembling the master cylinders or calipers, replace the brake fluid. Normally check the
brake fluid level and add fluid as required.
• On the inner parts of the master cylinders and calipers, replace the oil seals every two years.
• Replace the brake hoses every four years, or if cracked or damaged.
WARNING
Indicates a potential hazard that could result in serious injury or death.
ITEM ROUTINE
Whichever
comes first
INITIAL EVERY
month 1 3 6 6 12
km
(mi)
320
(200)
1,300
(800)
2,500
(1,600)
2,500
(1,600)
5,000
(3,200)
hours 20 80 160 160 320
Cooling system
• Check coolant leakage.
• Repair if necessary.
• Replace coolant every 24 months.
Air filter element
• Clean.
• Replace if necessary. Every 20 ~ 40 hours
(More often in wet or dusty areas.)
Engine oil • Replace. (Warm engine before draining.)
Engine oil filter car-
tridge
• Replace.
Engine oil strainer* • Clean.
Final gear oil
• Check oil level/oil leakage.
• Replace every 12 months.
Differential gear oil
Front brake*
• Check operation/fluid leakage. (See NOTE page 22.)
• Correct if necessary.
Rear brake*
• Check operation/fluid leakage. (See NOTE page 22.)
• Correct if necessary.
Select lever safety
system cable* • Check operation.
• Adjust if necessary.
V-belt*
• Check operation.
• Check for cracks or damage.
Wheels*
• Check balance/damage/runout.
• Repair if necessary.
Wheel bearing*
• Check bearing assemblies for looseness/damage.
• Replace if damaged.
Front and rear
suspension* • Check operation.
• Correct if necessary.
Steering system*
• Check operation./Replace if damaged.
• Check toe-in./Adjust if necessary.
Drive shaft universal
joint*
• Lubricate with lithium-soap-based grease.
Engine mount* • Check for cracks or damage.
Axle boots*
• Check operation.
• Replace if damaged.
Fittings and fasten-
ers* • Check all chassis fittings and fasteners.
• Correct if necessary.
Lights and switches*
• Check operation.
• Adjust headlight beams.