Yamaha WaveRunner FX Cruiser SHO, Руководство по обслуживанию

Страница: 10 / 433

1-5
E
GEN
INFO
5. Keep a supply of clean, lint-free cloths for
wiping up spills, etc.
6. Maintain good standards of personal and
industrial hygiene.
Good working practices
Special service tool
Use the recommended special service tools to
protect parts from damage. Use the right tool
in the right manner; do not improvise.
Tightening torques
Follow the tightening torque specifications pro-
vided throughout the manual. When tightening
nuts, bolts, and screws, tighten the large sizes
first, and tighten fasteners starting in the cen-
ter and moving outward.
Non-reusable parts
Always use new gaskets, seals, O-rings, cotter
pins, circlips, etc., when installing or assem-
bling parts.
Disassembly and assembly
1. Use compressed air to remove dust and
dirt during disassembly.
2. Apply oil or fluid to the contact surfaces of
moving parts before assembly.
3. Install bearings with the manufacture iden-
tification mark in the direction indicated in
the installation procedure. In addition, be
sure to lubricate the bearings liberally.
4. Apply a thin coat of water resistant grease
to the lip and periphery of an oil seal
before installation.
5. Check that moving parts operate normally
after assembly.
Safety while working