Trouble recovery
94
ler, jet pump housing, and jet thrust noz-
zle.
If debris is difficult to remove, consult a
Yamaha dealer.
EJU43473
Raising the reverse gate (EX
DELUXE / EX LIMITED)
If the RiDE system malfunctions and the re-
verse gate remains in the lowered position,
the watercraft will not be able to move for-
ward.
After raising the reverse gate so that the wa-
tercraft can move forward, immediately re-
turn to shore and have a Yamaha dealer
service the watercraft.
To raise the reverse gate:
(1) Stop the engine and remove the clip from
the engine shut-off switch.
(2) Enter the water and move to the rear of
the watercraft.
(3) Slide the shift rod joint toward the bow,
and then disconnect the shift rod joint
from the ball joint.
(4) Raise the reverse gate to the forward po-
sition.
TIP
While the shift rod is disconnected, the re-
verse gate will not move to the neutral po-
sition or reverse position even if the RiDE
lever is squeezed.
If the RiDE lever is squeezed while the shift
rod is disconnected, the watercraft will
move forward.
EJU34642
Jumping the battery
If the watercraft battery has run down, the en-
gine can be started using a 12-volt booster
battery and jumper cables.
EJU34666
Connecting the jumper cables
EWJ01252
To avoid battery explosion and serious
damage to the electrical system:
Do not reverse the polarity of the jumper
cables when connecting to the batter-
ies.
Do not connect the negative (–) jumper
cable to the negative (–) terminal of the
watercraft battery.
Do not touch the positive (+) jumper ca-
ble to the negative (–) jumper cable.
1
Shift rod joint
2
Ball joint
1
2
1
Reverse gate
2
Forward position
1
2
UF3Y16E0.book Page 94 Tuesday, August 9, 2022 11:18 AM
Содержание WaveRunner EX 2023
Страница 14: ...General and important labels 8 EX SPORT F3K U41D5 20 5 UF3Y16E0 book Page 8 Tuesday August 9 2022 11 18 AM ...
Страница 108: ...UF3Y16E0 book Page 102 Tuesday August 9 2022 11 18 AM ...
Страница 110: ...Printed in U S A August 2022 1 2 1 CR DIC183 F3YF8199160080 Barcode F3YF8199160080 ...