Control function operation
31
EJU31026
Watercraft control functions
EJU31153
Engine stop switch “ ”
The engine stop switch (red button) stops the
engine when the switch is pushed.
EJU31164
Engine shut-off switch “
”
The engine shut-off switch automatically
stops the engine when the clip, on the end of
the engine shut-off cord (lanyard), is removed
from the switch, such as if the operator falls
off the watercraft.
Insert the clip under the engine shut-off
switch before starting the engine.
When the engine is not running, remove the
clip from the engine shut-off switch to pre-
vent accidental starting or unauthorized op-
eration by children or others.
EJU44350
Start switch “
”
ECJ01311
Do not run the engine over 4000 r/min on
land. Also, do not run the engine for more
than 15 seconds without supplying water,
otherwise the engine could overheat.
The start switch (green button) starts the en-
gine when the switch is pushed.
Release the start switch as soon as the en-
gine starts to run. If the engine does not start
in 5 seconds, release the start switch, wait 15
seconds, and then try again.
NOTICE:
Never
push the start switch while the engine is
running. Do not operate the start switch
for more than 5 seconds, otherwise the
battery will be discharged and the engine
1
Engine stop switch
1
Engine shut-off switch
2
Clip
3
Engine shut-off cord (lanyard)
1
1
2
3
UF3Y14E0.book Page 31 Friday, June 12, 2020 10:50 AM
