Periodic maintenance and adjustment
45
ESU13471
Tool kit
The service information included in this man-
ual and the tools provided in the owner’s tool
kit are intended to assist you in the perfor-
mance of preventive maintenance and minor
repairs. However, additional tools such as a
torque wrench may be necessary to perform
certain maintenance work correctly.
NOTICE
ECS00961
Before starting the engine, make sure that
the tools are properly seated in their hold-
er.
TIP
If you do not have a torque wrench available
during a service operation requiring one, take
your snowmobile to a Yamaha dealer to
check the torque settings and adjust them if
necessary.
ESU14231
Recommended equipment
It is good practice to carry the spare parts
and other necessary equipment with you
while riding the snowmobile so that minor re-
pairs can be done if necessary. The following
should be carried at all times:
Flashlight
Roll of plastic tape
Steel wire
Tow rope
V-belt
Light bulbs
When you start out for a long distance trip,
extra fuel should be carried as well.
ESU15020
Opening and closing the shroud
and removing and installing the
right side cover
WARNING
EWS00811
Be sure the shroud and right side cover
are secured before operation. A loose
shroud or cover could move and cause
loss of control.
Shroud
To open the shroud
Unhook the shroud latches, and then slowly
raise the shroud forward until it stops.
To close the shroud
Slowly lower the shroud to its original posi-
tion, and then hook the shroud latches.
Right side cover
To remove the right side cover
1.
Open the shroud. (See the above proce-
dure.)
2.
Remove the bolts, and then remove the
side bumper.
1. Tool kit
1
1. Shroud
2. Shroud latch
2
1
2
U8KWS1E0.book Page 45 Tuesday, May 17, 2016 1:49 PM
