Yamaha VF90, Руководство пользователя

Страница: 34 / 212

Components
28
3. Install the cap.
EMU25996
Engine shut-off cord (lanyard) and clip
The clip must be attached to the engine shut-
off switch for the engine to run. The cord
should be attached to a secure place on the
operator’s clothing, or arm or leg. Should the
operator fall overboard or leave the helm, the
cord will pull out the clip, stopping ignition to
the engine. This will prevent the boat from
running away under power.
WARNING! At-
tach the engine shut-off cord to a secure
place on your clothing, or your arm or leg
while operating. Do not attach the cord to
clothing that could tear loose. Do not
route the cord where it could become en-
tangled, preventing it from functioning.
Avoid accidentally pulling the cord during
normal operation. Loss of engine power
means the loss of most steering control.
Also, without engine power, the boat
could slow rapidly. This could cause peo-
ple and objects in the boat to be thrown
forward.
[EWM00123]
EMU26092
Main switch
The main switch controls the ignition system;
its operation is described below.

“ ” (off)
With the main switch in the “ ” (off) posi-
tion, the electrical circuits are off, and the key
can be removed.

“ ” (on)
1. Throttle friction adjuster
1. Throttle friction adjuster
ZMU07026
1
ZMU069 8 9
1
1. Engine shut-off cord (lanyard)
2. Clip
3. Engine shut-off switch
1. Engine shut-off cord (lanyard)
2. Clip
3. Engine shut-off switch
ZMU07027
3
2
1
ZMU04565
1
2
3
U6HK30E0.book Page 28 Wednesday, December 13, 2017 5:32 PM
©
2019 Yamaha Motor Corporation, U.S.A.