Yamaha Vector RS90RX, Руководство пользователя

Страница: 61 / 90

Periodic maintenance
55
9. Rotate the secondary sliding sheave
clockwise and push it so that it separates
from the secondary fixed sheave.
10. Install the V-belt between the secondary
sliding and fixed sheaves.
11. Install the drive guard, and then install the
left side cover and the shroud.
ESU12100
Drive chain housing
WARNING
EWS00430
The engine, oil tank, brake disc, and cool-
ant hoses will be very hot after the engine
has been run. Avoid contact while they are
still hot with any part of your body or cloth-
ing during inspection or repair.
To check the drive chain housing oil level
1.
Place the snowmobile on a level surface.
2. Remove the shroud and the right side
cover. (See page 40 for removal proce-
dures.)
3. Remove the dipstick, wipe it off with a
clean rag, and then insert it back into the
filler hole.
4. Remove the dipstick and check that the
oil is between the maximum and mini-
mum level marks. If the oil is below the
minimum level mark, add sufficient oil of
the recommended type to raise it to the
maximum level mark.
1. Secondary sliding sheave
2. Secondary fixed sheave
1. V-belt
1. Dipstick
1. Maximum level mark
2. Minimum level mark
U8GM10E0.book Page 55 Friday, April 27, 2007 6:43 PM