Tyros4 Reference Manual
7
1
Vo
ices –
Playing the
K
eyboar
d
–
Selecting the Harmony/Echo type
You can select the desired Harmony/Echo effect from a variety of types.
1
Turn the [HARMONY/ECHO] button on.
2
Call up the operation display.
[FUNCTION]
[F] HARMONY/ECHO
3
Use the [1
]–[3
] buttons to select the Harmony/Echo
type.
The Harmony/Echo types are divided into the following groups, depending on the
particular effect applied.
Harmony Types
When one of the Harmony Types is selected, the Harmony effect is applied to the
note played in the right-hand section of the keyboard according to the type
selected above and the chord specified in the chord section of the keyboard shown
below.
When the [MONO] button is turned to
on or you use the SA/SA2 Voices, the
Harmony/Echo effect may not work
properly.
NOTE
Harmony Types
These types apply the harmony effect to notes played in the right-hand section of the
keyboard according to the chord specified in the left-hand section of the keyboard.
(Note that the “1+5” and “Octave” settings are not affected by the chord.)
Multi Assign Type
This type applies a special effect to chords played in the right-hand section of the
keyboard.
Echo Types
These types apply echo effects to notes played in the right-hand section of the key-
board in time with the currently set tempo.
Chord section for Style playback
and Harmony effect
Chord section for
Style playback and
Harmony effect
LEFT Voice and chord section
for Harmony effect
Split Point
Split Point
RIGHT 1–3 Voices
RIGHT 1–3 Voices
LEFT Voice
Split Point
(for Style playback)
Split Point
(for the Voice)
NEXT PAGE
