TX6n/5n/4n Owner’s Manual
9
Basic Operation of the TXn
By pressing a function button you can move to the screen
indicated above that button. By pressing the [HOME] button
you can move to the HOME screen. By pressing the [EXIT]
button you can move to the screen one level above.
Use encoders A and B to move to the parameter that you
want to edit, and use encoder B to edit the value.
• When you edit a parameter in the UTILITY screen,
press the [ENTER] button to confirm it after you finish
editing. A parameter that has not been confirmed will
flash. If you move the cursor or move to a different
screen without confirming the parameter, your change
will not be applied.
When the display shows the attenuator (i.e., in the HOME
screen or the METER screen), you can use encoders A and B
to adjust each channel’s attenuation.
• If the display shows a screen other than the HOME
screen or METER screen, encoders A and B are used
to set parameters.
To display the meter, access the HOME screen and press the
left-most function button (METER). You can change the
meter type by using the left-most function button (PREV)
and the right-most function button (NEXT).
Panel Operations
Encoder B
[ENTER] button
[EXIT] button
[HOME] button
Function buttons
Encoder A
About the Display
Switching Screens
Editing the Parameters
Shows the names of the screens
assigned to the function buttons.
Shows the contents of the
selected screen.
Shows an alert message if a problem occurs
or if a user-specified event occurs.
NOTE
Adjusting the Attenuator
Displaying the Meter
NOTE
Attenuator
Level meter
