Yamaha TT250RA, Руководство пользователя

Страница: 74 / 88

PERIODIC MAINTENANCE AND ADJUSTMENT
7-35
1
2
3
4
5
6
7
8
9
drive chain adjusting plates.
TIP
●
Make sure that there is enough
space between the brake pads be-
fore inserting the brake disc be-
tween the brake pads.
●
Make sure that the wheel axle is
inserted from the left-hand side
and that the drive chain adjusting
plates are installed with the
punched sides facing to the out-
side.
3. Install the axle nut, and then lower
the rear wheel so that it is on the
ground.
4. Adjust the drive chain slack. (See
page 7-21.)
5. Tighten the axle nut to the speci-
fied torque, and then install the cot-
ter pin.
WARNING! Always use a
new cotter pin for the axle
nut.
[EWA10701]
EAU25851
Troubleshooting
Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur dur-
ing operation. Any problem in the fuel,
compression, or ignition systems, for
example, can cause poor starting and
loss of power.
The following troubleshooting chart
represents a quick and easy procedure
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look like
Yamaha parts, but they are often inferi-
or, have a shorter service life and can
lead to expensive repair bills.
WARNING
EWA15141
When checking the fuel system, do
not smoke, and make sure there are
no open flames or sparks in the ar-
ea, including pilot lights from water
heaters or furnaces. Gasoline or
gasoline vapors can ignite or ex-
plode, causing severe injury or
property damage.
Tightening torque:
Axle nut:
105 Nm (10.5 m·kgf, 76 ft·lbf)