Perio
d
ic maintenance an
d
a
d
justment
7-29
7
a jack either under each side of the
frame in front of the rear wheel or under
each side of the swingarm.
EAU24361
Front wheel
EAU56231
To remove the front wheel
WARNING
EWA10822
To avoi
d
injury, securely support the
vehicle so there is no
d
an
g
er of it
fallin
g
over.
1. Loosen the axle nut.
2. Lift the front wheel off the ground
according to the procedure in the
previous section “Supporting the
motorcycle”.
3. Remove the axle nut and washer.
4. Pull the wheel axle out, and then
remove the wheel.
NOTICE:
Do
not apply the
b
rake after the
wheel an
d
b
rake
d
isc have
b
een
remove
d
, otherwise the
b
rake
pa
d
s will
b
e force
d
shut.
[ECA11073]
To install the front wheel
1. Lift the wheel up between the fork
legs.
TIP
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc into the caliper.
2. Insert the wheel axle, and then in-
stall the washer and axle nut.
3. Lower the front wheel so that it is
on the ground.
4. Tighten the axle nut to the speci-
fied torque.
5. Push down hard on the handlebar
several times to check for proper
fork operation.
1. Washer
2. Axle nut
Ti
g
htenin
g
torque:
Axle nut:
45 N·m (4.5 kgf·m, 33 lb·ft)
U2PT17E0.book Page 29 Monday, March 30, 2020 2:13 PM
Содержание TT-R125LWE
Страница 1: ...PRINTED IN BRAZIL 2020 04 JC E TT R125LWE 2PT F8199 17 LIT 11626 34 46 ...
Страница 10: ...Location of important labels 1 2 1 U2PT17E0 book Page 2 Monday March 30 2020 2 13 PM ...
Страница 84: ...U2PT17E0 book Page 2 Monday March 30 2020 2 13 PM ...
Страница 86: ...PRINTED IN BRAZIL 2020 04 JC E TT R125LWE 2PT F8199 17 LIT 11626 34 46 ...