Operation an
d
important ri
d
in
g
points
7-3
7
EAU16675
Shiftin
g
Shifting gears lets you control the
amount of engine power available for
starting off, accelerating, climbing hills,
etc.
The gear positions are shown in the il-
lustration.
TIP
To shift the transmission into the neu-
tral position (
), press the shift pedal
down repeatedly until it reaches the
end of its travel, and then slightly raise
it.
NOTICE
ECA10262
When shiftin
g
, press the shift
pe
d
al firmly until you feel the
g
ear shift is complete.
Even with the transmission in
the neutral position,
d
o not
coast for lon
g
perio
d
s of time
with the en
g
ine off, nor tow the
motorcycle for lon
g
d
istances.
The transmission is properly lu-
b
ricate
d
only when the en
g
ine is
runnin
g
. Ina
d
equate lu
b
rication
may
d
ama
g
e the transmission.
Always use the clutch while
chan
g
in
g
g
ears to avoi
d
d
am-
a
g
in
g
the en
g
ine, transmission,
an
d
d
rive train, which are not
d
esi
g
ne
d
to withstan
d
the
shock of force
d
shiftin
g
.
EAU85370
To start out an
d
accelerate
1. Pull the clutch lever to disengage
the clutch.
2. Shift the transmission into first
gear. The neutral indicator light
should go out.
3. Open the throttle gradually, and at
the same time, release the clutch
lever slowly.
4. After starting out, close the throt-
tle, and at the same time, quickly
pull the clutch lever in.
5. Shift the transmission into second
gear. (Make sure not to shift the
transmission into the neutral posi-
tion.)
6. Open the throttle part way and
gradually release the clutch lever.
7. Follow the same procedure when
shifting to the next higher gear.
EAU85380
To
d
ecelerate
1. Release the throttle and apply
both the front and the rear brakes
smoothly to slow the motorcycle.
2. As the vehicle decelerates, shift to
a lower gear.
3. When the engine is about to stall
or runs roughly, pull the clutch le-
ver in, use the brakes to slow the
motorcycle, and continue to
downshift as necessary.
1. Gear positions
2. Shift pedal
2
1
1
N
2
3
4
5
6
UB4T20E0.book Page 3 Tuesday, April 4, 2023 9:44 AM