TF Series & Tio1608-D
9
www.yamahaproaudio.com
Freely patching by Dante Controller
To build a more flexible system, you can manually patch the Dante
network between the TF series and Tio1608-D by using the Dante
controller software instead of the Quick Config function. For example, if
you want to change the output destination according to the installation
position of the amp rack or monitor speakers, you can change the patches
with Dante controller.
Setup Procedure
Download the installer appropriate for your computer's OS from the
Audinate website shown below, and install the Dante Controller software.
https://www.audinate.com/products/software/dante-controller
Following this, connect your computer to the Dante connector on either
your TF Series or the Tio1608-D with a network cable. When you wish to
freely change just the output patches, turn the Quick Config function on
the TF Series and Tio1608-D ON, with the TF Series "with OUTPUT" option
turned OFF. This will automatically patch only the inputs. When you wish
to freely patch the inputs as well, turn the Quick Config function on the TF
Series and Tio1608-D OFF.
When you start the Dante Controller, all devices on the Dante network will
be automatically detected. Open the Dante Controller "Routing" screen to
do the I/O patching. The channels on the transmitting devices (shown in
each column) and the channels of the receiving devices (shown in each
row) are displayed in a grid. Patch the I/O on this grid according to your
needs.
Dante Controller "Routing" screen
S
T
E
R
E
O
O
U
T
L
S
T
E
R
E
O
O
U
T
R
S
U
B
O
U
T
AU
X
O
U
T
1
-12
Tio1608-D
(ID: 1)
Tio1608-D
(ID: 2)
NY64-D
