Yamaha Tenere 700 2020, Руководство по обслуживанию

Страница: 90 / 472

PERIODIC MAINTENANCE
3-25
b. Lubricate the O-ring of the new oil filter
cartridge with a thin coat of engine oil.
NOTICE
ECA25890
Make sure the O-ring is positioned correctly
in the groove of the oil filter cartridge.
c. Tighten the new oil filter cartridge to spec-
ification with an oil filter wrench.
7. Install:
• Engine oil drain bolt
(along with the gasket )
8. Fill:
• Oil pan
(with the specified amount of the recom-
mended engine oil)
9. Install:
• Engine oil filler cap
(along with the O-ring )
10.Start the engine, warm it up for several min-
utes, and then turn it off.
11.Check:
• Engine
(for engine oil leaks)
12.Check:
• Engine oil level
Refer to “CHECKING THE ENGINE OIL
LEVEL” on page 3-24.
13.Install:
• Engine guard
Refer to “ENGINE REMOVAL” on page 5-3.
EAS30810
MEASURING THE ENGINE OIL PRESSURE
1. Stand the vehicle on a level surface.
TIP
• Place the vehicle on a suitable stand.
• Make sure that the vehicle is upright.
2. Check:
• Engine oil level
Below the minimum level mark “a”
→
Add the
recommended engine oil to the proper level.
3. Start the engine, warm it up for several min-
utes, and then turn it off.
NOTICE
ECA13410
When the engine is cold, the engine oil will
have a higher viscosity, causing the engine
oil pressure to increase. Therefore, be sure
to measure the engine oil pressure after
warming up the engine.
4. Remove:
• Engine guard
Refer to “ENGINE REMOVAL” on page 5-3.
5. Tilt the vehicle to the left so that oil does not
flow out of the main gallery.
6. Remove:
• Main gallery bolt “1”
WARNING
EWA12980
The engine, muffler and engine oil are ex-
tremely hot.
T
R
.
.
Oil filter cartridge
17 N·m (1.7 kgf·m, 13 lb·ft)
T
R
.
.
Engine oil drain bolt
43 N·m (4.3 kgf·m, 32 lb·ft)
Engine oil quantity
Without oil filter cartridge re-
placement
2.30 L (2.43 US qt, 2.02 Imp.qt)
With oil filter cartridge replace-
ment
2.60 L (2.75 US qt, 2.29 Imp.qt)
Quantity (disassembled)
3.00 L (3.17 US qt, 2.64 Imp.qt)
1 2
New
New
a