Yamaha Tenere 700 2020, Руководство по обслуживанию

Страница: 114 / 472

FRONT WHEEL
4-15
EAS30151
ASSEMBLING THE FRONT WHEEL
1. Install:
• Wheel bearings
• Oil seals
a. Install the new wheel bearing (left side).
NOTICE
ECA18110
Do not contact the wheel bearing inner race
“1” or balls “2”. Contact should be made
only with the outer race “3”.
TIP
Use a socket “4” that matches the diameter of
the wheel bearing outer race.
b. Install the spacer.
c. Install the new wheel bearing (right side).
TIP
Place a suitable washer “1” between the socket
“2” and the bearing so that both the inner race
“3” and outer race “4” are pressed at the same
time, and then press the bearing until the inner
race makes contact with the spacer “5”.
EAS30152
ADJUSTING THE FRONT WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the front
wheel static balance should be adjusted.
• Adjust the front wheel static balance with the
brake disc installed.
1. Remove:
• Balancing weight(s)
2. Find:
• Front wheel’s heavy spot
3. Adjust:
• Front wheel static balance
4. Check:
• Front wheel static balance
EAS32231
INSTALLING THE FRONT WHEEL
1. Install:
• Front wheel sensor rotor
• Front brake discs
NOTICE
ECA21011
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
• Replace the brake disc bolts and wheel
sensor rotor bolts with new ones.
TIP
• Install the wheel sensor rotor with the stamped
mark “a” facing outward.
• Tighten the brake disc bolts and wheel sensor
rotor bolts in stages and in a crisscross pattern.
a
New
New
G0 888 9 8
T
R
.
.
Front wheel sensor rotor bolt
8 N·m (0.8 kgf·m, 5.9 lb·ft)
LOCTITE®
Front brake disc bolt
18 N·m (1.8 kgf·m, 13 lb·ft)
LOCTITE®
G0 888 99