Yamaha SY99, Руководство пользователя

Страница: 193 / 344

MULTI PLAY MODE
Copy multi
Summary: Anytime in multi play mode you can copy
the currently selected multi to another multi
memory.
Procedure:
From: multi play mode (JUMP #300, #301)
Press: COPY
Specify: the destination to which the multi will
be copied.
To execute: the copy operation press F8 (Go).
To quit: without executing press EXIT.
The names of the sixteen multis in Internal or Card
memory are displayed as explained in Multi Direc-
tory. Press INTERNAL or CARD, and press a memory
select button 1-16 to specify the copy destination.
After specifying the copy destination press F8
(Go). You will be asked "Are you sure?" If you are
sure you want to copy the multi, press YES and the
data will be copied. To quit without copying press
NO.
Note: If you copy a multi from internal memory to
card memory, all internal voice numbers used by
that multi will be converted into card voice num -
bers. In the same way, if you copy a multi from
card memory to internal memory, all card voice
numbers used by that multi will be converted into
internal voice numbers.
Send bank select and program change
Summary: While in multi play mode you can trans- 1.
mit bank select and program change messages
from MIDI OUT without affecting the SY99's
own tone generator. This allows you to switch a
tone generator module connected to the SY99
MIDI OUT to another memory without changing 2.
the SY99's own memory selection. (An identical
function is available in voice play mode.) 3.
Procedure:
From: multi play mode (JUMP #300)
Select: Fl (Send)
Specify: a bank select number (1-16,384) and
a program change number (1-128).
To transmit: the bank select and program change
messages press ENTER.
To quit: without sending a bank select or pro-
gram change message, press EXIT.
Use the numeric key pad to enter a number be-
tween 1 and 16,384, then press ENTER to move
the cursor to the program change item. (To send
a program change message but no bank select
message, simply press ENTER.)
Use the numeric key pad to enter a number be-
tween 1 and 128.
Press ENTER and the specified bank select and
program change messages will be transmitted
on the (keyboard transmit channel (Kyb Trans
Ch) specified in MIDI Utility job 1.Setting (JUMP
#807).
If, for the program change, you enter a num-
ber below 1 it will be transmitted as 1. If you
enter a number above 128, it will be transmitted
as 128.
In addition to the program change message
transmitted by this function, a program change
message will be transmitted every time you se-
lect a SY99 voice or multi unless Program
Change has been turned off using MIDI utility
job 1.Setting, page 258.
182