OPERATION AND IMPORTANT RIDING POINTS
5-2
5
NOTICE
ECA11834
If a warnin
g
or in
d
icator li
g
ht
d
oes
not come on initially when the key is
turne
d
to “ON”, or if a warnin
g
or in-
d
icator li
g
ht remains on, see pa
g
e
3-4 for the correspon
d
in
g
warnin
g
an
d
in
d
icator li
g
ht circuit check.
The ABS warning light should
come on when the key is turned to
“ON”, and then go off after travel-
ing at a speed of 10 km/h (6 mi/h)
or higher.
NOTICE
ECA17682
If the ABS warnin
g
li
g
ht
d
oes not
come on an
d
then
g
o off as ex-
plaine
d
a
b
ove, see pa
g
e 3-4 for the
warnin
g
li
g
ht circuit check.
2. Shift the transmission into the
neutral position. The neutral indi-
cator light should come on. If not,
ask a Yamaha dealer to check the
electrical circuit.
3. Start the engine by pushing
the “
” side of the start/engine
stop switch.
If the engine fails to start, release
the start/engine stop switch, wait
a few seconds, and then try again.
Each starting attempt should be
as short as possible to preserve
the battery. Do not crank the en-
gine more than 10 seconds on any
one attempt.
NOTICE
ECA11043
For maximum en
g
ine life, never ac-
celerate har
d
when the en
g
ine is
col
d
!
EAU16672
Shiftin
g
Shifting gears lets you control the
amount of engine power available for
starting off, accelerating, climbing hills,
etc.
The gear positions are shown in the il-
lustration.
TIP
To shift the transmission into the neu-
tral position, press the shift pedal down
repeatedly until it reaches the end of its
travel, and then slightly raise it.
1. Shift pedal
2. Neutral position
1
2
6
5
4
3
2
1
N
U2BSE0E0.book Page 2 Tuesday, September 17, 2013 8:55 AM