Yamaha Super Tenere ES 2023, Руководство пользователя

Страница: 64 / 132

Operation an d important ri d in g points
6-2
6
EAU58252
Startin g the en g ine
In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:

The transmission is in the neutral
position.

The transmission is in gear with
the clutch lever pulled and the
sidestand up.
See page 4-42 for more informa-
tion.
1. Turn the key to “ON” and make
sure that the start/engine stop
switch is set to “
”.
The following warning lights and
indicator lights should come on for
a few seconds, then go off.

Oil level warning light

Engine trouble warning light

Traction control system indi-
cator light

Cruise control indicator lights

Suspension system warning
light
NOTICE
ECA11834
If a warnin g or in d icator li g ht d oes
not come on initially when the key is
turne
d to “ON”, or if a warnin g or in-
d icator li g ht remains on, see pa g e
4-2 for the correspon d in g warnin g
an d in d icator li g ht circuit check.
The ABS warning light should
come on when the key is turned to
“ON”, and then go off after travel-
ing at a speed of 10 km/h (6 mi/h)
or higher.
NOTICE
ECA17682
If the ABS warnin g li g ht d oes not
come on an d then g o off as ex-
plaine d a b ove, see pa g e 4-2 for the
warnin g li g ht circuit check.
2. Shift the transmission into the
neutral position. The neutral indi-
cator light should come on. If not,
ask a Yamaha dealer to check the
electrical circuit.
3. Start the engine by pushing
the “ ” side of the start/engine
stop switch.
If the engine fails to start, release
the start/engine stop switch, wait
a few seconds, and then try again.
Each starting attempt should be
as short as possible to preserve
the battery. Do not crank the en-
gine more than 10 seconds on any
one attempt.
NOTICE
ECA11043
For maximum en g ine life, never ac-
celerate har d when the en g ine is
col d !
UBUY10E0.book Page 2 Tuesday, October 4, 2022 10:55 AM