Instrument an
d
control functions
3-20
3
EAU1234M
Han
d
le
b
ar switches
Left
Ri
g
ht
EAUM4031
Dimmer/Pass switch “
/
/PASS”
Set this switch to “
” for the high
beam and to “
” for the low beam.
To flash the high beam, press the
switch down to “PASS” while the
headlights are on low beam.
TIP
When the switch is set to low beam,
both headlights come on.
When the switch is set to high beam,
both headlights come on.
EAU12461
Turn si
g
nal switch “
/
”
To signal a right-hand turn, push this
switch to “
”. To signal a left-hand
turn, push this switch to “
”. When
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
EAU12501
Horn switch “
”
Press this switch to sound the horn.
EAU54212
Stop/Run/Start switch “
/
/
”
To crank the engine with the starter,
set this switch to “
”, and then push
the switch down towards “
”. See
page 5-2 for starting instructions prior
to starting the engine.
Set this switch to “
” to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
EAU12735
Hazar
d
switch “
”
With the key in the “ON” or “
” posi-
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
1. Menu switch “MENU”
2. Select switch “
/
”
3. Cruise control switches
4. Horn switch “
”
5. Turn signal switch “
/
”
6. Dimmer/Pass switch “
/
/PASS”
1. Stop/Run/Start switch “
/
/
”
2. Drive mode switch “MODE”
3. Hazard switch “
”
RE
S
SE
T
PA
SS
1
6
5
4
2
3
MODE
STOP
RUN
STA
RT
3
2
1
UBP8E1E0.book Page 20 Friday, September 14, 2018 11:35 AM
