Yamaha SR10RDG 2015, Руководство оператора

Страница: 25 / 54

23
SNO-482

NOTE: If the oil and engine are not
at operating temperature, the oil
level may read too low. Always make
sure the engine is at operating tem-
perature before checking the oil.
14. Install the access plate and torx-head
screws beneath the snowmobile; then
install the hood and access panels.
Coolant Level

NOTE: Use a good quality, eth-
ylene glycol-based, automotive-type
coolant.
Locate the filler neck located above the
resonator; then remove the coolant cap
from the filler neck. Verify that the coolant
is at the bottom of the tab in the filler neck.
0747-547
Locate the coolant tank above the drive
clutch; then remove the plug from the
coolant tank. Add coolant to the full level
on the tank. Install the plug.
0747-766
Spark Plugs

NOTE: Always use the recom-
mended spark plugs in the engine.
See the appropriate specifications
sheet for correct spark plug gap.
1. Disconnect the main harness from the
ignition coils; then remove the ignition
coils from the cylinder head cover.
2. Remove the three spark plugs.

NOTE: Prior to installing the spark
plugs, check the gap between the
electrode and ground strap. The
clearance should be 0.7-0.8 mm
(0.028-0.031 in.).
3. Install new spark plugs. Tighten to
1.3 kg-m (9.4 ft-lb).
4. Install the ignition coils onto the cyl-
inder head cover making sure they
are fully seated. Connect the main
harness to the ignition coils.
5. Install the hood and access panels.
! WARNING
Always check the coolant level with
the engine cold.
CAUTION
If the coolant is below the neck and if
coolant has been added, immediately
inspect for leakage and/or damage. If
leakage or damage is detected, take
the snowmobile to an authorized
Yamaha Snowmobile dealer for ser-
vice. If not under warranty, this ser-
vice is at the discretion and expense
of the snowmobile owner.
CAUTION
If adjusting spark plug gap is neces-
sary, do not use the center electrode
as a leverage point. Damage to the
plug may occur.