Yamaha SPX1000, Руководство по эксплуатации, Страница: 31 / 79

PARAMETERS ACCESSED BY THE INT PARAM
KEY
Stereo or Mono x 2 Output (OUT MODE): ST, MONO
x 2
When set to ST (stereo), the outputs of the left and right-
channel processors are mixed and the output signal is
delivered in stereo. When MONO x 2 is selected the left and
right-channel processors are completely independent.
Reverb Low-pass Filter Frequency (REV LPF): 1 – 16
kHz, THRU
Permits rolling off the high-frequency content of the REV
signal above the set frequency. The LPF is OFF when set to
THRU.
34. REV
PARAMETERS ACCESSED BY THE PARAM KEY
Chorus Modulation Frequency (MOD FRQ.): Refer to
CHORUS on page 18.
Chorus Delay Modulation Depth (DM DEPTH): 0% –
100%
This sets the amount by which the delay time of one delay
signal is varied in relation to the other, and thus the depth of
the CHORUS effect.
Chorus Amplitude Modulation Depth (AM DEPTH):
0% – 100%
Sets the amount by which the amplitude (level) of the input
signal is varied.
Rev Reverb Time (REV TIME): Refer to REV 1 HALL on
page 14.
Rev High Frequency Reverb Time Ratio (REV HIGH): Refer
to REV 1 HALL on page 14.
Rev Diffusion (REV DIF): Refer to REV 1 HALL on page 14.
Rev Initial Delay (REV DLY): Refer to REV 1 HALL on page
14.
PARAMETERS ACCESSED BY THE INT PARAM
KEY
Stereo or Mono x 2 Output (OUT MODE): ST, MO
x 2
When set to ST (stereo), the outputs of the left and right-
channel processors are mixed and the output signal is
delivered in stereo. When MONO x 2 is selected the left and
28
right-channel processors are completely independent.
Reverb Low-pass Filter Frequency (REV LPF): 1 – 16
kHz, THRU
Permits rolling off the high-frequency content of the REV
signal above the set frequency. The LPF is OFF when set to
THRU.
35. PAN + PAN
PARAMETERS ACCESSED BY THE PARAM
KEY
1 Channel Pan Type (1 PAN TYP): Refer to PAN on page 24.
1 Channel Pan Speed (1 SPEED): Refer to PAN on page 24.
1 Channel Pan Front/Rear Depth (1 F/R DPT): Refer to PAN
on page 24.
1 Channel Pan Left/Right Depth (1 L/R DPT): Refer to PAN
on page 24.
1 Channel Pan Initial Delay (1 DLY): Refer to PAN on page
24.
2 Channel Pan Type (2 PAN TYP): Refer to PAN on page 24.
2 Channel Pan Speed (2 SPEED): Refer to PAN on page 24.
2 Channel Pan Front/Rear Depth (2 F/R DPT): Refer to PAN
on page 24.
2 Channel Pan Left/Right Depth (2 L/R DPT): Refer to PAN
on page 24.
2 Channel Pan Initial Delay (2 DLY): Refer to PAN on page
24.
1/2 Channel Pan Phase (PHASE): -180 – +180 degrees
Determines the starting phase of the 2-channel pan (PAN 2) in
relation to the left-channel pan (PAN 1).