38
Chapter 4—Basic Operation
SREV1—Owner’s Manual
Meter I/O Page
Input and output signal levels for all channels can be metered by using the 11-segment
meters on the Meter I/O pages shown below, which are located by using the [UTILITY]
button.
The 11-segment LCD meters have the following resolution:
CLIP, –3 dB, –6dB, –9 dB, –12dB, –15 dB, –18dB, –24 dB, –30dB, –36 dB, –42dB
SREV1 SIGNAL and CLIP indicators
Input and output signal levels for each channel can be metered by using the SIGNAL
and CLIP indicators on the SREV1 front panel. The SIGNAL indicators light up when
the signal is 34 dB below clipping and are intended to show the presence of a signal,
while the CLIP indicators light up when the signal is actually clipping.
RC-SREV1 CLIP indicators
Input and output signal levels for each channel can be metered for clipping by using the
CLIP indicators on the RC-SREV1. These indicators light up when a signal is clipping.
2-ch mode
4-ch mode
2-ch x2 mode
INPUT
OUTPUT
CLIP
SIGNAL
1
2
1
2
3
CH
4
3
4
48K
44.1K
FS LOCK
INPUT CLIP
OUTPUT CLIP
CH
1 2 3 4
