112
APPENDIX
Troubleshooting
Bluetooth™
Remote control
Display
Cause
Remedy
See
page
Searching...
The Yamaha Bluetooth wireless
audio receiver and the Bluetooth
component are in the process of
pairing.
—
The Yamaha Bluetooth wireless
audio receiver and the Bluetooth
component are in the process of
establishing a connection.
—
Completed
The pairing is completed.
—
Canceled
The pairing is canceled.
—
BT connected
The connection between the
Yamaha Bluetooth wireless audio
receiver and the Bluetooth
component is established.
—
Disconnected
The Bluetooth component is
disconnected from the Yamaha
Bluetooth wireless audio receiver.
—
Not found
The Bluetooth component is not
found.
During pairing:
–
pairing must be performed on the
Bluetooth component and this unit
simultaneously. Check if the Bluetooth
component is in pairing mode.
During connecting:
–
check if the Bluetooth component is
turned on.
–
check if the Bluetooth component is
within 10 m (32 feet) of the Yamaha
Bluetooth wireless audio receiver.
—
Pairing may not have been
achieved.
Try pairing again.
Problem
Cause
Remedy
See
page
The remote control
does not work or
function properly.
Wrong distance or angle.
The remote control will function within a
maximum range of 6 m / 20 ft, and no more
than 30 degrees off-axis from the front
panel.
—
Direct sunlight or lighting (from
an inverter type of fluorescent
lamp, strobe light, etc.) is striking
the remote control sensor of this
unit.
Adjust the lighting angle, or reposition this
unit.
—
The batteries are weak.
Replace all batteries.
The remote control ID of the
remote control and this unit do not
match.
Match the remote control ID of this unit and
the remote control.
External components
cannot be controlled
using the remote
control.
The remote control code is not
correctly set.
Set the remote control code correctly using
“
” on the CD-
ROM.
—
Try setting another code for the same
manufacturer using “
” on the CD-ROM.
—
If this unit does not work when you press
Cursor
B
/
C
/
D
/
E
, do the following.
When the key does not work during DVD
disc menu operation: press the
Input
selector
again.
When there is no response with remote
control operation of the OPTION menu/
Setup menu: press
SOURCE/RECEIVER
(it should glow orange) and try operating the
remote control again.
—
Even if the remote control code is
correctly set, there are some
models that do not respond to the
remote control.
—
Содержание RX-V667
