34
En
Optimizing the speaker setting for your listening room
If an error or warning message appears, see “Error and
warning messages” (page 32).
10
Move the optimizer microphone to the
second listening position and then press
9
ENTER
to start the measurement.
y
To skip the measurements at the remaining listening
positions, press
9
n
.
11
Repeat step 10 until the measurement at all
listening positions are made.
If you have made the measurement at all listening
positions or skipped the measurement at the
remaining listening positions, “Measurement
Completed Successful” appears.
12
Follow steps 7 to 9 in “Basic automatic
setup” (page 31) to view the measurement
results and turn off the GUI menu.
Use this feature to review the result of the automatic setup.
You can also reload the automatic setup parameters in case
you are not satisfied with the speaker setup and sound
adjustments you have configured manually.
If you reload the automatic setup parameters, the settings you
have configured manually are cleared. To save the settings
before reloading the automatic setup parameters, see “System
Memory” (page 90).
1
Set the operation mode selector to
F
AMP
and then press
I
MENU
.
The GUI menu appears in the video monitor.
y
If the menu directory other than “Top Menu” (page 68) is
displayed, press and hold
I
MENU
to display the top GUI
menu.
2
Press
9
k
/
n
repeatedly to select “Setup”
and then press
9
h
.
3
Press
9
k
/
n
repeatedly to select “Auto
Setup” and then press
9
h
.
4
Press
9
k
to select “Information” and then
press
9
h
.
5
Press
9
k
/
n
repeatedly to select the
parameter of which you want to check the
setting.
Note
Reviewing and reloading the
automatic setup parameters
Note
