Playback of Bluetooth® device contents
Connect a paired Bluetooth device and start playback. Check the following
beforehand:
• Pairing has been completed.
• Bluetooth function on the Bluetooth device is turned on.
1
Operate the Bluetooth device to establish a Bluetooth connection.
Select the model name of the unit from the Bluetooth device list on your
device.
When a connection is established, the unit’s input source automatically
switches to “Bluetooth”.
Note
▪ If you do not want the input source to switch automatically when a connection is established, set
“Input Interlock” (p.47) to “Off” in the “Option” menu.
▪ You can operate the unit to search and connect the Bluetooth device (only the most recently
connected device). In that case, follow one of the procedures below.
– Switch the input source to “Bluetooth”.
– Press ENTER while the input source is “Bluetooth”. Otherwise, press OPTION and use the
cursor keys to select “Connect”.
▪ If you cannot connect the device, please perform pairing again.
2
Operate the Bluetooth device to play back music.
Note
▪ You cannot operate the unit to select or play back music, or display informations such as song
names.
▪ Follow one of the procedures below to disconnect a Bluetooth connection.
– Perform the disconnect operation on the Bluetooth device.
– Press ENTER.
– Press OPTION and use the cursor keys to select “Disconnect”.
– Switch the unit's input source to other than “Bluetooth”.
– Press the SETUP key, then use the cursor keys to select "Bluetooth", then "Disconnect".
Enjoying audio using Bluetooth® speakers/
headphones
Follow the procedure below to establish a Bluetooth connection between Bluetooth
speakers/headphones and the unit.
1
Use the input selection keys on the remote control to select an
input source.
Select an input source other than Bluetooth.
2
Press SETUP.
3
Use the cursor keys to select “Bluetooth” and press ENTER.
4
Use the cursor keys to set “Bluetooth” to “On”, and then set
“Transmitter” to “On” in the same way.
5
Use the cursor keys to select “Device Search” to search the
Bluetooth devices.
The list of Bluetooth devices is displayed.
6
Select the Bluetooth speakers/headphones to be connected with
the unit and press ENTER.
When the connection process finishes, audio played back on the unit will
be reproduced from the Bluetooth speakers/headphones.
Note
▪ If the desired Bluetooth device is not displayed on the list, set the Bluetooth device to the pairing
mode and then select “Device Search”.
▪ Follow one of the procedures below to terminate the Bluetooth connection.
– Perform the disconnect operation on the Bluetooth speakers/headphones.
– Press the SETUP key, then use the cursor keys to select "Bluetooth", then "Transmitter", and
then "Off".
En
43
