Listening to FM/AM radio
You can tune into a radio station by specifying its frequency or selecting from
registered radio stations.
Note
▪ The radio frequencies differ depending on the country or region where the unit is being used. The
explanation of this section uses a display with frequencies used in U.K. and Europe models.
▪ If you cannot obtain good reception on the radio, adjust the direction of the FM/AM antennas.
Setting the frequency steps
(Asia, Taiwan, Brazil and General models only)
At the factory, the frequency step setting is set to 50 kHz for FM and 9 kHz for AM.
Depending on your country or region, set the frequency steps to 100 kHz for FM and
10 kHz for AM.
1
Set the unit to standby mode.
2
When holding down STRAIGHT on the front panel, press
z
(power).
(power)
z
STRAIGHT
PROGRAM
3
Press PROGRAM repeatedly to select “TU”.
ENHANCER
LINK
ECO
MASTER
OUT
2
-R
es
Hi
YPAO VOL. A - DRC
SLEEP
STEREO
PARTY
TUNED
ZONE
3 B
2 A
VOL.
FPR
SL
SW
SR
SBL
SB
SBR
FPL
MUTE VIRTUAL
TU••••FM50/AM9
4
Press STRAIGHT to select “FM100/AM10”.
5
Press
z
(power) to set the unit to standby mode and turn it on
again.
Selecting a frequency for reception
1
Press FM/AM to select a band.
“TUNER” is selected as the input source and then the frequency currently
selected is displayed.
ENHANCER
LINK
ECO
MASTER
OUT
2
-R
es
Hi
YPAO VOL. A - DRC
SLEEP
STEREO
PARTY
TUNED
ZONE
3 B
2 A
MUTE VIRTUAL
VOL.
FM 87.50MHz
En
37