18
En
CONNECTIONS
5
Hook the speaker terminal wrench onto the
WRENCH HOLDER on the rear panel of this
unit when not in use.
■
Connecting to the SP2 speaker
terminals
Connect Zone 2 or Zone 3 speakers to these terminals (see
page 121).
1
Open the tab.
2
Insert one bare wire into the hole on the
terminal.
3
Close the tab to secure the wire.
■
Connecting the banana plug
(except U.K., Europe, Asia and Korea
models)
The banana plug is a single-pole electrical connector
widely used to terminate speaker cables.
1
Tighten the knob using the supplied speaker
terminal wrench.
2
Insert the banana plug connector into the
end of the corresponding terminal.
y
You can also use the banana plug with the SP2 speaker terminals.
Open the tab and then insert one banana plug into the hole on the
terminal. Do not close the tab after connecting the banana plug.
Red: positive (+)
Black: negative (–)
Banana plug
Red: positive (+)
Black: negative (–)
Speaker terminal wrench
Содержание RX-V2700
Страница 904: ......