CONNECTIONS
Connecting speakers
En
22
3
Check that “SPEAKER IMP.” is displayed on the
front panel.
4
Press STRAIGHT repeatedly to select a “6
Ω
MIN.”
5
Switch this unit to the standby mode, and then
switch it on again.
The power turns on, when the settings you made has been
configured.
■
Connecting speakers
This type of jack can connect to the following speakers or
connection.
1
Remove approximately 10 mm of insulation from the
ends of the speaker cables, and twist the bare wires
of the cables together firmly so that they will not
cause short circuits.
2
Loosen the speaker terminals.
3
Insert the bare wire of the speaker cable into the gap
on the side of the terminal.
4
Tighten the terminal.
■
Connecting the subwoofers
1
Connect the subwoofer input jack to the
SUBWOOFER 1 and/or 2 jack on this unit with an
audio pin cable.
J
1
2
Set the subwoofer volume as follows.
Volume: Set to approximately half volume (or slightly less than
half).
Crossover frequency (if available): Set to maximum.
•
Front L/R speakers
•
Center speaker
•
Surround L/R speakers
•
Surround back L/R speakers
•
Presence L/R speakers
•
Zone2/Zone3 speakers
•
Bi-amp connection (Front L/R speakers)
S P E A K E R I M P .
8 M I N
FR
ONT
-
2
2
3
1
4
4
+
NOTE
After connection, applying this setting to this unit is required to
activate all speaker connections. With using “Power Amp
Assign” function, you can easily apply the speaker
configuration.
Refer to “Power Amp Assign” (
) for details on using
“Power Amp Assign” function.
(SIN
GLE)
(REAR
)
SUBW
OOFER
(FRO
NT)
PRE OUT
CEN
TER
CEN
TER
SUR.
BACK
SURR
UND
1
2
VOLUME
MIN
MAX
CROSSOVER/
HIGH CUT
MIN
MAX
Subwoofer examples
J
1 :
When only one subwoofer is used, connect the subwoofer to the
SUBWOOFER1 jack.
