Firmware Update Procedure for RX-V2065
Page.7 of 7
Troubleshooting
Case #1:
“
UPDATE FAIL
” appeared during the USB update.
Cause: For some reason, the receiver can’t read the firmware data.
For your solution, please check the following;
9
USB drive is securely connected to the receiver.
9
USB drive is inserted before the receiver is powered on for the update.
9
The firmware data, RX-V2065_xxxx.bin is stored in the root directory of
the USB drive.
9
There is no other data but the firmware data in the USB drive.
9
No folders are created in the USB drive.
Else,
Retry the update using another USB drive.
Case #2:
Error message appeared during the Network update.
“UPDATE FAIL”
Solution: Perform USB update (See page 3)
“VER.CHECK ERR”
Solution: Check your network environment
Case #3:
Firmware update doesn’t start for other reasons.
Receiver doesn’t power up after the update.
Or, “
ERROR
” appeared when confirming the firmware version.
To recover, perform following alternative USB update method
1. Unplug the AC power cable from the back of the receiver.
2. Insert the USB thumb drive into the USB terminal located on the front panel.
(The firmware must be downloaded and copied into the USB drive in prior)
3. Press and hold the
TONE CONTROL
button and keep it pressed while you plug
the AC power cable back into the receiver again.
“FILE READING”
will appear
on the front display. Then, release the
TONE CONTROL
button.
4. The update will start automatically.
5. When “
UPDATE SUCCESS
” appears on the display, firmware update is
completed. Power off the receiver and remove the USB thumb drive.
6. Confirm updated firmware version.
TONE CONTROL
USB Drive
