Yamaha RX V1900 - AV Receiver, Руководство пользователя

Страница: 98 / 146

94
En
Remote control features
7
Press
F
SETUP
again to exit the setup
menu.
• “ERROR” appears in the display window (
4
) on the remote
control if you press a button not indicated in the respective step,
or when you press more than one button simultaneously.
• This remote control can learn approximately 200 functions.
However, depending on the signals learned, “FULL” may
appear in the display before you program 200 functions. In this
case, clear unnecessary programmed functions to make room
for further learning (page 97).
• Learning may not be possible in the following cases:
– when the batteries in the remote control for this unit or other
components are weak.
– when the remote control is exposed to direct sunlight.
– when the function to be programmed is continuous or
uncommon.
You can change the name of the control area (input
source) that appears in the display window (
4
) on the
remote control.
1
Set the operation mode selector to
E
SOURCE
and then press an input selector
button (
3
) to select the desired control area.
2
Press
F
SETUP
using a ballpoint pen or
similar object.
“SETUP” appears in the display window.
3
Press
8 k
/
n
repeatedly to select “RNAME”
and then press
8
ENTER
.
4
Press
8
k
/
n
repeatedly to select 3-letter
name or 5-letter name you want to edit and
then press
8
ENTER
.
Each control area has both 3-letter name and 5-letter
name. You can rename the 3-letter name and 5-letter
name independently.
5
Edit the name of the control area.
To locate the position to edit , press
8 l
/
h
.
To select a character, press
8 k
/
n
.
y
Press
8 k
to change the character in the following order,
or press
8 n
to go in the reverse order: A to Z, a to z, 0 to
9, space, symbols (–, +, /, :).
6
Press
8
ENTER
to set the new name.
“OK” appears in the display window (
4
) on the
remote control if renaming was successful.
y
When you want to rename the another control area, press
the input selector button (
3
) or
5
SELECT
l
/
h
repeatedly to select the desired control area and then press
8
ENTER and then carry out the operations of steps 4
through 6.
7
Press
F
SETUP
again to exit the setup
menu.
“ERROR” appears in the display window (
4
) on the remote
control if you press a button not indicated in the respective step,
or when you press more than one button simultaneously.
Notes
Changing source names in the
display window
BD BD/HD
3-letter name 5-letter name
Note
BD/HD