93
En
Graphical user interface (GUI) menu
AD
V
ANCED
OPERA
T
ION
Use this feature to manually adjust the basic speaker
settings. Most of the “Speaker” parameters are set
automatically when you run the automatic setup.
y
• Set “Test Tone” to “On” to output the test tone for the
“Configuration”, “Distance” and “Level” settings.
• If your subwoofer can adjust the output volume and the
crossover frequency, set the volume to about half way (or
slightly less) and set the crossover frequency to the maximum.
■
Configuration (Speaker configurations)
Front (Front speakers)
When “Bass Out” is set to “Front” (page 94), you can select
only “Large” in “Front”. If the value of “Front” is set to other
than “Large” in advance, this unit change the value to “Large”
automatically.
Center (Center speaker)
Surround (Surround left/right speakers)
Surround Back
(Surround back left/right speakers)
If you are only using one surround back speaker, connect it to
the SUR.BACK SINGLE jack, and configure the “Surround
Back L” settings under “Distance” and “Level”.
Cross Over (Cross over)
Use this feature to select the crossover frequency of the
speaker(s) that is set to “Small”. All frequencies below the
selected frequency will be sent to the subwoofer or to the
speakers set to “Large” in “Configuration”.
Choices: 40Hz, 60Hz,
80Hz
, 90Hz, 100Hz, 110Hz,
120Hz, 160Hz, 200Hz
Front Presence (Front presence speakers)
Use this feature if you want to use the front presence
speakers connected to this unit.
Subwoofer (Subwoofer)
Phase (Subwoofer phase)
Use this feature to switch the phase of your
subwoofer if bass sounds are lacking or unclear.
Setup (Speaker)
Measure for the speaker size
The woofer section of a speaker is
– 16 cm (6.5 in) or larger: large
– smaller than 16 cm (6.5 in): small
Choice
Descriptions
Large
Select this setting when the front speakers
are large.
Small
Select this setting when the front speakers
are small.
Note
Choice
Descriptions
Large
Select this setting when the center speaker is
large.
Small
Select this setting when the center speaker is
small.
None
Select this setting when you do not use the
center speaker. The center channel signals
are directed to the front left and right
speakers.
Choice
Descriptions
Large
Select this setting when the surround
speakers are large.
Small
Select this setting when the surround
speakers are small.
None
Select this setting when you do not use the
surround speakers. This unit is set to the
Virtual CINEMA DSP mode (page 51), and
“Surround Back” is automatically set to
“None”.
Choice
Descriptions
Large x1
Select this setting when the single surround
back speaker is large.
Small x1
Select this setting when the single surround
back speaker is small.
Small x2
Select this setting when the surround back
left and right speakers are small.
Large x2
Select this setting when the surround back
left and right speakers are Large.
None
Select this setting when you do not use the
surround back speakers. The surround back
channel signals are directed to the surround
left and right speakers.
Note
Choice
Descriptions
Yes
Select this setting when you use the front
presence speakers.
None
Select this setting when you do not use the
front presence speakers.
Choice
Functions
Normal
Does not change the phase of your subwoofer.
Reverse
Sets the phase of the subwoofer to reverse.
