Control functions
14
been reached), the tripmeter must be reset
after the oil change for the next periodic oil
change to be indicated at the correct time.
In that case, reset the oil change tripmeter as
follows.
To reset the oil change tripmeter (when the
engine oil was changed before the oil change
tripmeter appeared)
1.
Push the “SELECT” button until “ODO”
is displayed, and then push the “RESET”
button for at least 1 second. The dis-
tance traveled since the last oil change
and “OIL” will flash alternately in the
odometer display.
2.
Push the “RESET” button for approxi-
mately 3 seconds. “00000” and “OIL” will
flash alternately in the odometer display
3 times, and then the display will return
to the previous display mode.
Clock
The clock uses a 12-hour time system.
To set the clock
1.
Turn the key to the on position.
2.
Push the “SELECT” button and “RESET”
button simultaneously until the hour dig-
its start flashing.
3.
Push the “RESET” button to change the
hour setting, and then push the “SE-
LECT” button. The minute digits will start
flashing.
4.
Push the “RESET” button to change the
minute setting, and then push the “SE-
LECT” button. The clock starts when the
“SELECT” button is released.
TIP
The clock must be set again when the battery
is disconnected.
Drive mode display
This display indicates which drive mode has
been selected: “S”, “T” or “E”. For more de-
tails on the modes and on how to select
them, refer to page 16.
Display brightness control
This function allows you to adjust the bright-
ness of the meter unit display to suit the out-
door lighting conditions.
To adjust the display brightness
1.
Turn the key to the off position.
1. Clock
F
E
1
1. Drive mode display
1. Display brightness level
1
1
U8JV70E0.book Page 14 Monday, April 6, 2015 11:49 AM
