Yamaha RS90NL, Дополнительное руководство по обслуживанию

Страница: 44 / 156

39
CHAS
STEERING
3. Install:
• Tie rod
1
• Locknuts
2
• Joints
3
4. Check:
• Tie rod angle
c
CAUTION:
After tightening the inside and outside ball joint
locknut
2
, make sure the tie rod
1
can be
rotated freely through the ball joint travel. If not,
loosen the locknut
2
and re-position the ball
joint so that the tie rod
1
can be rotated freely.
Tighten the locknut to specification.
È
Left side
É
Right side
È
Tie rod part
number
É
Set length
a
Ê
Tie rod
length
b
8ES-23830-00
(RS90N/
RS90NR/
RS90RS/
RS90GT)
424.0 mm
(16.69 in) 361.0 mm
(14.21 in)
8FW-23830-00
(RS90MS) 374.0 mm
(14.72 in) 311.0 mm
(12.24 in)
Tie rod angle:
47°
È É
5. Install:
• Tie rods
1
NOTE:
• Make sure that the indentation
a
on the tie rod
faces out.
• The threads on both rod ends must be the same
length.
CAUTION:
Always use new cotter pins.
6. Bend the lock washer tab along a flat side of the
bolt.
T
R
.
.
Tie rod end locknut:
25 Nm (2.5 m · kg, 18 ft · lb)
LOCTITE
®
Tie rod-idler arm nut:
30 Nm (3.0 m · kg, 22 ft · lb)
Tie rod-steering arm nut:
35 Nm (3.5 m · kg, 25 ft · lb)