reface Reference Manual
5
Setting the EG (envelope generator)
You can adjust the shape of the envelopes applied to the operators by using the [EG level] and [EG
rate] buttons. Volumes and modulation degrees are set on the EG Level screen; rates of change
are set on the EG Rate screen.
EG levels can be set between “0” (minimum) and “127” (maximum) for each operator.
For carriers, these levels set the volume; for modulators, they set the degree of modulation.
1.
Press the [EDIT] button to activate Edit mode.
2.
Press the [EG level] button.
The EG Level Settings screen is displayed.
3.
If necessary, press the [EG level] button several times to switch between operators.
4.
Change the settings for Level 1 to Level 4 by using the sliders.
5.
If necessary, alternately use the [EG level] and [EG rate] buttons to adjust the overall shape of the envelope.
6.
When you have finished making settings, press the [EDIT] button once again to leave Edit mode.
z
EG Level Settings screen
EG Level
1
Level 1
0 to 127
Attack level
2
Level 2
Decay level
3
Level 3
Sustain level
4
Level 4
Release level
For settings other than “0”, the sound will stop when it reaches the Level 4 setting.
Level 1
Level 2
Level 3
Level 4
Level
Rate 1
Rate 2
Rate 3
Rate 4
Time
Key on
Key off
1
2
3
4
