Yamaha RCX222, Руководство пользователя

Страница: 193 / 524

4-94 4-95
Chapter
4
OPERA
TION
11. "MANUAL" mode
11.2.5 Copying point data
Point data can be copied under another point number.
n
NOTE
If a hand system flag is set in the point data, the hand system flag will also
be copied.
[Procedure]
1) Press (COPY) in "MANUAL>POINT" mode.
The message "Copy(####-####,####)>" appears on the guideline.
■
Copying point data (1)
MANUAL >POINT 50% [MG][S0H0X]
————————————x———————y———————z———————r———
P30 = 100.00 250.00
P31 = 50.00 100.00
P32 = 122.62 -24.54
Copy(####-####,####)>
COMNT : [ ]
[POS] 50.00 100.00 0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
2) Use to , and to enter the point number range for the copy
source and the point number for the copy destination in the following format and
press .
"(copy start number) – (copy end number), (copy destination number)"
For example, to copy the data between P30 and P34 onto the lines after P50, enter
"30 - 34, 50" and press .
A confirmation message appears on the guideline.
n
NOTE
Valid point numbers are from 0 to 9999.