Yamaha R1 Series 2015, Руководство по обслуживанию, Страница: 672 / 704

ELECTRICAL COMPONENTS
8-191
d. Heat the coolant or let it cool down to the
specified temperatures.
e. Measure the coolant temperature sensor re-
sistance.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Install:
•
Coolant temperature sensor
EAS30581
CHECKING THE THROTTLE POSITION
SENSOR
1. Remove:
•
Throttle position sensor
(from the throttle body)
NOTICE
ECA17540
• Handle the throttle position sensor with
special care.
• Never subject the throttle position sensor
to strong shocks. If the throttle position
sensor is dropped, replace it.
2. Check:
• Throttle position sensor maximum resistance
Out of specification
o
Replace the throttle
position sensor.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Connect the pocket tester (
: u
1 k) to the
throttle position sensor terminals as shown.
b. Measure the throttle position sensor maxi-
mum resistance.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Install:
•
Throttle position sensor
TIP
When installing the throttle position sensor, ad-
just its angle properly. Refer to “ADJUSTING
THE THROTTLE POSITION SENSOR” on page
7-16.
EAS30582
CHECKING THE ACCELERATOR POSITION
SENSOR
1. Remove:
• Accelerator position sensor
(from the throttle body)
WARNING
EWA15960
• Handle the accelerator position sensor with
special care.
• Never subject the accelerator position sen-
sor to strong shocks. If the accelerator po-
sition sensor is dropped, replace it.
2. Check:
• Accelerator position sensor maximum resis-
tance
Out of specification
o
Replace the accelera-
tor position sensor.
Coolant temperature sensor
16 Nm (1.6 m·kgf, 12 ft·lbf)
Resistance
1.40–2.60 k
:
T
R
.
.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe
blue “1”
•
Negative tester probe
black/green “2”
B L B / G W
2
1