Yamaha R1 Series 2015, Руководство по обслуживанию

Страница: 360 / 704

CAMSHAFTS
5-19
EAS30269
INSTALLING THE CAMSHAFTS
1. Remove:
•
Timing mark accessing bolt “1”
• Crankshaft end cover “2”
2. Align:
• Mark “a” on the generator rotor
(with the generator rotor cover slot “b”)
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Turn the crankshaft counterclockwise.
b. When piston #1 is at BTDC105
q
, align the
BTDC105
q
mark “a” on the generator rotor
with the generator rotor cover slot “b”.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Install:
•
Exhaust camshaft “1”
• Intake camshaft “2”
TIP
•
Hang the timing chain on the sprocket from the
exhaust camshaft to the intake camshaft.
•
The intake camshaft sprocket timing mark “a”
and exhaust camshaft sprocket timing mark “b”
should align with the cylinder head surface “c”.
• Check the timing mark position of the camshaft
sprocket using a mirror.
• The timing chain (exhaust side) should be
stretched and the timing chain (intake side)
should be sagged.
4. Install:
•
Camshaft cap
TIP
Make sure each camshaft cap is installed in its
original place. Refer to the identification marks
as follows:
“1”: camshaft cap mark for cylinder #1
“2”: camshaft cap mark for cylinder #2
“3”: camshaft cap mark for cylinder #3
“4”: camshaft cap mark for cylinder #4
5. Tighten:
• Camshaft cap bolts
TIP
•
If the camshaft cap bolt is a new one, it is not
necessary to apply engine oil onto the mating
surface and threads of the bolt.
• If the camshaft cap bolt is a new one, tighten it
to 10 Nm (1.0 m·kgf, 7.2 ft·lbf).
• Tighten the camshaft cap bolts in stages and in
a crisscross pattern, working from the inner
caps out.
NOTICE
ECA17430
• Lubricate the camshaft cap bolts with the
engine oil.
• The camshaft cap bolts must be tightened
1
2
a
b
Camshaft cap bolt
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
Camshaft cap bolt (new)
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
1 2 a b c c
1 2 3 4
T
R
.
.