44
En
ADVANCED SETUP
When using multiple Yamaha receivers or amplifiers with
the same default code setting, you may unintentionally
operate those components simultaneously. In this case, set
one of the alternative codes for this unit to operate this
unit separately.
• Switching to ID1
Press and hold the ID button and the numeric button
“1” on the remote control together for about 3 seconds.
• Switching to ID2
Press and hold the ID button and the numeric button
“2” on the remote control together for about 3 seconds.
*
When you change the remote control ID, you must
change the remote control ID of this unit (see page 43).
If the remote control batteries are weak or removed, the remote
control ID will switch to the default setting (ID2). In this case,
replace the batteries and set the remote control ID again.
Switching the remote control ID
Remote control ID
*
(this unit’s setting)
Function
ID1
To operate this unit using
an alternative code.
ID2
(default setting)
To operate this unit using
the default code.
Note
1
2
ID
1
2
ID
Содержание R-S700BL
Страница 1: ...Receiver OWNER S MANUAL U ...
Страница 71: ...Printed in Malaysia WV17360 2010 Yamaha Corporation ...