OUTPUT channels
Reference Manual
47
Sending signals from MIX channels to the STEREO/
MONO bus
There are two ways to send signals to the STEREO bus or MONO bus: ST/MONO mode and
LCR mode. You can select the mode individually for each channel. Features of each mode
are the same as for input channels.
NOTE
Refer to “
Signal level when LCR mode is selected
for details on how the signal level
sent from an LCR mode MIX channel to each bus will change according to the operation of the
TO ST PAN knob.
TO STEREO/MONO window (8ch)
You can control the on/off and pan/balance settings of the signal sent from MIX channels to
the STEREO (L/R) bus and MONO (C) bus, in groups of eight channels.
1
Channel select button
Selects the channel. You can select multiple channels simultaneously.
2
Mode LEDs
The LED of the currently-selected mode will light.
STEP
1.
Use the Bank Select keys in the Fader Bank section and the [SEL] keys on the top
panel to select the MIX channel from which you want to send the signal to the
STEREO/MONO bus.
2.
In the PAN/BALANCE field, press a knob to select the channel you want to adjust in
the SELECTED CHANNEL VIEW screen, and then press the knob once again.
3.
Use the MODE select button in the TO STEREO/MONO window to select either ST/
MONO mode or LCR mode for each channel.
4.
In the MASTER section on the top panel, turn on the [ON] key for the STEREO
channel/MONO channel, and then raise the fader to an appropriate level.
5.
Turn on the [ON] keys for those channels, and use the fader in the Channel Strip
section to raise the master level of the MIX channel to an appropriate position.
The subsequent steps will differ depending on whether ST/MONO mode or LCR mode was
selected for the channel in step 3.
Channels for which ST/MONO mode is selected
6.
In the TO STEREO/MONO window, use the ST/MONO button to turn a signal sent
from the MIX channel to the STEREO bus/MONO bus on or off.
7.
Use the TO ST PAN knob to set the panning of the signal sent from the MIX channel
to the STEREO bus.
Channels for which LCR mode is selected
6.
Turn on the LCR button in the TO STEREO/MONO window.
7.
Press the CSR knob to select it, and use the [TOUCH AND TURN] knob to adjust the
level difference between signals sent from that channel to the STEREO (L/R) bus and
to the MONO (C) bus.
8.
Press the TO ST PAN knob to select it, and use the [TOUCH AND TURN] knob to
adjust the panning of signals sent from the MIX channel to the STEREO (L/R) bus
and MONO (C) bus, and the level balance of signals sent to the MONO (C) bus and
STEREO (L/R) bus.
SELECTED CHANNEL VIEW screen
TO STEREO/MONO window
1
8
9
2
3
6
5
4
7
ST/MONO mode
LCR mode
