11
PLG150-AP Owner’s Manual
Editing the AP Native Part Parameters
(Modular Synthesis Plug-in System)
The following explanations show how to edit the AP native part parameters when creating Plug-in
Voices, using the MOTIF ES Control Synthesizer as an example. Voices created on the PLG150-AP
are called Board Voices.
On MSPS / XG Plug-in System-compatible devices, you can edit the Board Voices using a variety of
parameter settings, such as effects or EQ (AP native parameters).
On MSPS-compatible devices, the entire Board Voice is edited as one element.
A Board Voice edited on the MSPS-compatible device is called a Plug-in Voice.
For information about how to save Plug-in Voices, refer to the owner’s manual of your MSPS-com-
patible device.
• Keep in mind that the parameter values and settings below represent offsets of the actual voice settings. This
means that adjustments made to the parameters may not make much change in the actual sound, depending
on the original settings of the voice. For parameter values, a setting of “0” results in no change, while positive
and negative values increase and decrease the value respectively.
1
Select the desired AP voice, as described in “Selecting AP Voices” on
page 10.
2
Enter the Voice Edit mode.
Press the [EDIT] button.
3
Select an element to be edited.
1) Press any one of the NUMBER buttons ([1] – [4]) to edit the element parameters.
2) Press the [F4] button to select the “NATIVE” element.
4
Select the desired parameter.
Use the cursor buttons to select the desired parameter.
• For a list of available parameters, see page 17.
5
Adjust the value or change the setting for the selected parameter.
Use the [INC/YES] and [DEC/NO] buttons or the data dial.
NOTE
NOTE