SYSTEM OPERATIONS
17
En
Eng
lish
BA
S
IC
OPE
R
A
T
IO
NS
BASIC OPERATIONS
Follow the procedure below to select an input source and adjust the sound settings on the system.
1
Press (On/Standby) to turn on the receiver.
Depending on input mode of the receiver, the DVD
player also turns on by the system control connection
(
p.8). The front panel display lights up.
y
This system has an auto-standby function (
p.35) which
automatically sets it to standby mode if not operated for
30 minutes while the receiver is set to DISC/USB input mode.
2
Press one of the input selection keys (or
rotate INPUT on the front panel) to select the
desired input source.
3
Start playback on the selected source
component or select a radio station.
For information on the disc/USB device playback,
see page 19, and for information on tuning, see
page 29.
4
Press /– (or turn VOLUME on the
front panel) to adjust the volume to the
desired output level.
5
Rotate BASS, TREBLE, or BALANCE on the
front panel of the receiver to adjust the
following settings.
BASS:
Adjusts the low frequency response.
TREBLE:
Adjusts the high frequency response.
BALANCE:
Adjusts the volume level of each left
and right speaker channel.
■
Pure Direct mode
Pure Direct mode bypasses the tone control circuit and
turns off the front panel display, allowing you to enjoy
pure high-fidelity sound.
Press PURE DIRECT (or PURE DIRECT on the
front panel) to turn on Pure Direct mode.
The front panel display automatically turns off. PURE
DIRECT on the front panel is backlit in blue.
Notes
• If you carry out operations while Pure Direct mode is turned on,
the front panel display lights up briefly to acknowledge the
command.
• While the Pure Direct mode is turned on, neither BASS,
TREBLE, nor BALANCE is available.
SYSTEM OPERATIONS
INPUT
BASS
PHONES
VOLUME
MIN
MAX
TREBLE
BALANCE
PRESET
PURE DIRECT
L
R
TP
TIMER
USB
INPUT
(On/Standby)
VOLUME
PURE
DIRECT
BASS
BALANCE
TREBLE
(On/Standby)
/–
Input selection
keys
PURE DIRECT
MUTE
Basic system operations