C
u
stomizing with F
u
nction Parameters
P-255 Owner’s Man
u
al
43
The following parameters can be used to adjust the split
point and make various other settings for Split mode in
order to best suit the piece you intend to play. Settings can
be made for each combination of Voices as described
below.
1
Activate Split mode, select the Voices you wish to
use, and then use the [FUNCTION] button to select
the Function parameter(s) you wish to set.
2
Change the setting(s) using the [-/NO] and [+/YES]
buttons.
Shortcut:
Yo
u
can j
u
mp directly to F
u
nction parameter
F4.1
b
y pressing
the [FU
N
CTIO
N
]
bu
tton with the [SPLIT]
bu
tton held down.
F4.1
Split point
Use this parameter to set the location at which the keyboard
is divided into the left and right sides. The key that defines
the split point is included in the left side of the keyboard.
• A
v
aila
b
le settings: A-1 to C7 (entire key
b
oard)
• Defa
u
lt setting: F
#
2
Examples of split points as shown on display
F4.2
Split balance
This parameter can be used to optimize the volume balance
between the split Voices. Settings can be made for each
combination of Voices.
• A
v
aila
b
le settings: 0 to 20 (The greater the
v
al
u
e, the lo
u
der the
v
ol
u
me of the right Voice; 10 represents an eq
u
al
b
alance.)
• Defa
u
lt setting: Each com
b
ination of Voices has its own defa
u
lt.
F4.3
Right Voice octave shift
F4.4
Left Voice octave shift
These parameters are used to raise or lower the pitch of
each of the left and right Voices in units of one octave. This
allows you to set the note ranges of each side of the key-
board to better suit the pieces you intend to play. Settings
can be made for each combination of Voices.
• A
v
aila
b
le settings: -1, 0, and 1
• Defa
u
lt setting: Each com
b
ination of Voices has its own defa
u
lt.
F4.5
Right Voice effect depth
F4.6
Left Voice effect depth
Use these parameters to set the depth of the effect for each
of the left and right Voices.
• A
v
aila
b
le settings: 0 to 20
• Defa
u
lt setting: Each com
b
ination of Voices has its own defa
u
lt.
F4.7
Damper pedal range
This parameter can be use to specify whether the damper
pedal should affect both Voices (“ALL”), only the right
Voice (“1”), or only the left Voice (“2”).
• A
v
aila
b
le settings: ALL (
b
oth Voices), 1 (right Voice only), and 2
(left Voice only)
• Defa
u
lt setting: 1
F4.8
Reset
By pressing the [+/YES] button with this Function parame-
ter shown, you can reset all of the Split mode settings to the
defaults for the corresponding Voice combinations.
The following parameters can be used to assign the func-
tionality of the [PLAY/STOP] button to a pedal, adjust the
depth of the damper pedal’s resonance effect, and make a
range of other convenient settings.
F5.1
Pedal [PLAY/STOP] function
If you have connected a pedal unit* (see page 12) to your
digital piano, you can use this parameter to configure either
the center or left pedal to operate in the same way as the
control panel’s [PLAY/STOP] button. Note that when this
functionality is assigned to a pedal, the pedal’s original
function (i.e., soft or sostenuto) will be disabled. (*: Sold
separately.)
• A
v
aila
b
le settings: OFF, 1 (left pedal), and 2 (center pedal)
• Defa
u
lt setting: OFF
F5.2
Damper-pedal resonance depth
Using this parameter, you can adjust the depth of the reso-
nance effect applied to certain Voices—specifically, Grand
Piano, Live Grand, Ballad Grand, and Bright Grand—when
the damper pedal is operated.
• A
v
aila
b
le settings: 0 to 10
• Defa
u
lt setting: Differs for each Voice
F5.3
Soft pedal effect depth
If you have connected a pedal unit* (see page 12), the soft
pedal will slightly lower the volume and soften the timbre
of notes played while it is being operated, and using this
parameter, you can adjust the depth of that effect. (*: Sold
separately.)
• A
v
aila
b
le settings: 1 to 10
• Defa
u
lt setting: 5
F4.
Split mode settings
• As an alternative to using the [-/NO] and [+/YES] buttons, the split point can be
set by pressing the corresponding key. You can also do this when Function
parameter
F4.1
is not being shown by pressing the key with the [SPLIT] button
NOTE
F 2 F~2 E_2
Indicates a sharp
key (
#
).
Indicates a flat
key (
b
).
F2
F
#
2
E
b
2
F5.
Pedal and special sound settings
Содержание P-255
Страница 58: ...P 255 Owner s Manual 58 ...
