PREPARATION
➤
Installation
En
10
Position the center unit so that the keys are on the far side of the center unit.
About the TV remote repeater
The center unit receives signals from the TV’s remote control via the remote control
sensor located on the front panel. It then transmits these signals from the TV remote
repeater located on the rear panel.
HINT
• This function is available only when the TV’s remote control uses infrared signals.
• The TV’s remote control can be used even when the unit is turned off as long as the unit’s power cable is
plugged into an AC wall outlet.
Mount the center unit on the wall so that the keys face upwards.
Installing the center unit on a TV stand, etc.
Caution
Position the center unit more than 5 cm (2 in) away from the TV to ensure proper transmission of signals
from the remote control to the remote control sensor on the TV.
Remote control sensor (front panel)
Keys
TV remote repeater
TV’s remote control
More than 5 cm (2 in)
TV remote control sensor
Mounting the center unit on a wall
Cautions
• When mounting the center unit on a wall, all installation work must be performed by a qualified
contractor or dealer. The customer must never attempt to perform this installation work. Improper or
inadequate installation could cause the center unit to fall, resulting in personal injury.
• To avoid falling the center unit, attach the center unit to a dry wall.
• Make sure you use commercially available screws that can support the weight of the installation
(specified in Step 2 on the next page). Using clamps other than specified screws, such as short screws,
nails, and two-sided tape, may cause the center unit to fall.
• Fix the cables in place where they will not become loose. If your foot or hand accidentally gets caught on
a loose cable, the center unit may fall.
• Do not lean on the center unit or apply excessive force to the top of the unit. Doing so may cause the
center unit to fall.
• Check that the center unit is fixed securely after the installation. Yamaha will bear no responsibility for
any accidents caused by improper installations.
Keys
Remote control sensor
(top panel)
