27
En
Eng
lish
TROUBLESHOOTING
AD
DITIONAL
INFO
RMA
T
ION
■
FM
■
iPod
Note
If a transmission error occurs but no status message is displayed on the front panel display of the receiver, check the connection between
the receiver and your iPod (
Problem
Cause
Remedy
See
page
FM stereo reception is noisy.
The characteristics of FM stereo
broadcasts may cause this problem
when the transmitter is too far away or
the antenna input is poor.
Check the antenna connections.
Try using a high-quality directional FM
antenna.
—
There is distortion, and clear
reception cannot be obtained
even with a good FM antenna.
There is multi-path interference.
Adjust the antenna position to eliminate
multi-path interference.
—
The desired station cannot be
tuned into with the automatic
tuning method.
The signal is too weak.
Use a high-quality directional FM antenna.
—
Use the manual tuning method.
Previously preset stations can
no longer be tuned into.
The receiver has been disconnected for
a long period.
Set preset stations.
Status message
Cause
Remedy
See
page
CONNECT ERR
There is a problem with the signal path
from your iPod to the receiver.
Turn off the receiver and try resetting your iPod.
UNKNOWN TYP
The iPod being used is not supported by
the receiver.
Only iPod (Click and Wheel), iPod nano, iPod
Classic, iPod mini and iPod touch are supported.
—
CONNECTED
Your iPod is properly stationed in the
iPod dock, and the connection between
your iPod and the receiver is complete.
NOT CONNECT
Your iPod was removed from the iPod
dock of the receiver.
Station your iPod back to the iPod dock of the
receiver.
CAN'T PLAY
The receiver cannot play back the songs
currently stored on your iPod.
Check that the songs currently stored on your iPod
are playable.
—
Store some other playable music files on your iPod.
—