Reference
Front & Rear Panels
MW8CX/MW10C Owner’s Manual
19
9
RETURN Control
Adjusts the level at which the signal received at the
RETURN jacks (L (MONO) and R) is sent to the STEREO
L/R bus.
If you supply a signal to the RETURN L (MONO) jack
only, the mixer sends the same signal to both the L
and R Stereo buses.
0
POWER Indicator
This indicator lights when the mixer’s power is ON.
A
Level Meter
This LED meter displays the level of the signal sent to the
STEREO OUT jacks, MONITOR jacks and the PHONES
jack. The “0” segment corresponds to the nominal output
level. The PEAK segment lights red when the output reaches
the clipping level.
B
2TR IN/USB
• 2TR IN/USB Switch
If it is set to TO STEREO (
), the signals input via the
2TR IN jacks and the USB connector are sent to the STE-
REO L/R bus. If this switch is set to TO MONITOR (
),
the signals are sent to the MONITOR OUT jacks, the
PHONES jack, and the level meter. The MONITOR MIX
feature becomes available when it is set to TO MONITOR
(
).
*
: When overdubbing, you can adjust the levels
of the monitor playback signal and the signal being recorded
separately.
MONITOR MIX Signal Flow
• 2TR IN/USB control
Adjusts the level of the signal sent from the 2TR IN jacks
and USB connector to the STEREO L/R bus.
C
MONITOR/PHONES Control
Controls the level of the signal output to the PHONES jack
and the MONITOR jacks.
D
STEREO Master Control
Adjusts the signal level sent to the STEREO OUT jacks.
Jack List
* These jacks will also accept connection to monaural phone connectors. If you use monaural plugs, the connection will be unbalanced.
NOTE
Playback
signal
Recording
signal
2TR IN/
USB
2TR IN/USB control
STEREO Master control
MONITOR/PHONES controls
STEREO
bus
REC OUT/USB
MONITOR/
PHONES jacks
* Impedance Balanced
Since the hot and cold terminals of impedance bal-
anced output jacks have the same impedance, these
outputs are less affected by induced noise.
Input and Output Jacks
Polarities
Configurations
MIC INPUT
Pin 1: Ground
Pin 2: Hot (+)
Pin 3: Cold (-)
LINE INPUT (stereo channels)
STEREO OUT, MONITOR, EFFECT (AUX)*
Tip: Hot (+)
Ring: Cold (-)
Sleeve: Ground
INSERT
Tip: Output
Ring: Input
Sleeve: Ground
PHONES
Tip: L
Ring: R
Sleeve: Ground
RETURN
LINE INPUT (monaural channels)
Tip: Hot
Sleeve: Ground
OUTPUT
INPUT
XLR Connector
Tip
Sleeve
Ring
TRS Phone Connector
Tip
Sleeve
Phone Connector
