101
M I D I D a t a F o r m a t
2.2.1.3 Multi Effect1 bulk dump
This message sets the MULTI EFFECT1 block (refer to tables
<1 - 1>, <1 - 4>).
2.2.1.4 Multi Part bulk dump
This message sets the MULTI PART block (refer to tables
<1 - 1>, <1 - 6>).
2.2.1.5 Drums Setup bulk dump
This message sets the DRUMS SETUP block (refer to tables
<1 - 1>, <1 - 7>).
2.3 Parameter request
This message requests transmission of a parameter value.
The output is transmitted in the Parameter Change message
format (refer to 2.1.3).
2.3.1 XG parameter request
This message requests transmission of XG parameter settings.
Settings are transmitted in the format of an XG parameter
change (refer to 2.1.3).
11110000
F0H
Exclusive status
01000011
43H
YAMAHA ID
0011nnnn
3NH
N:device Number
01001100
4CH
Model ID
0ggggggg
GGH
Address High
0mmmmmmm
MMH
Address Mid
0lllllll
LLH
Address Low
11110111
F7H
End of Exclusive
2.4 Dump request
This message requests transmission of a specific block of
parameter values.
The output is the same as the bulk dump format.
2.4.1 XG dump request
This message requests transmission of all parameters of the
specified block of XG parameters.
The output is the same as the format of XG bulk dump (refer to
2.2.1).
11110000
F0H
Exclusive status
01000011
43H
YAMAHA ID
0010nnnn
2NH
N:device Number
01001100
4CH
Model ID
0ggggggg
GGH
Address High
0mmmmmmm
MMH
Address Mid
0lllllll
LLH
Address Low
11110111
F7H
End of Exclusive
Address is valid only when the beginning of the block has been
specified.
3. Realtime messages
3.1 Active sensing
This message is used to prevent problems which could occur if
a MIDI cable were to be disconnected or broken
during a perfor mance.When this message is received, the
MU100R will begin monitoring the state of the MIDI cable.
a) Transmission
not transmitted.
b) Receive
Once FE has been received, failure to receive any
MIDI message for an interval longer than approxi-
mately 300 msec will cause processing to be
performed as if ALL SOUND OFF, ALL NOTE OFF,
and RESET ALL CONTROLLERS messages were
received, and the unit will reset to a condition in which
FE was never received.