Yamaha MT-07M 2015, Руководство пользователя

Страница: 50 / 110

Operation an d important ri d in g points
6-2
6
NOTICE
ECA20790

If the a b ove warnin g or in d icator
li g hts d o not come on initially
when the key is turne d to “ON”,
or if a warnin g or in d icator li g ht
(except the oil pressure warnin g
li g ht) remains on, see pa g e 4-4
for the correspon d in g warnin g
an d in d icator li g ht circuit check.

After g oin g off once, the oil
pressure warnin g li g ht will
come b ack on until the en g ine is
starte d . If the warnin g li g ht d oes
not come on, or if the warnin g
li g ht d oes not g o off after start-
in g the en g ine, see pa g e 4-4 for
the en g ine oil pressure warnin g
li g ht circuit check.
For ABS models:
The ABS warning light should
come on when the key is turned to
“ON”, and then go off after travel-
ing at a speed of 10 km/h (6 mi/h)
or higher.
NOTICE
ECA17682
If the ABS warnin g li g ht d oes not
come on an d then g o off as ex-
plaine d a b ove, see pa g e 4-4 for the
warnin g li g ht circuit check.
2. Shift the transmission into the
neutral position. The neutral indi-
cator light should come on. If not,
ask a Yamaha dealer to check the
electrical circuit.
3. Start the engine by sliding the
switch toward “ ”.
If the engine fails to start, release
the start/engine stop switch, wait
a few seconds, and then try again.
Each starting attempt should be
as short as possible to preserve
the battery. Do not crank the en-
gine more than 10 seconds on any
one attempt.
NOTICE
ECA11043
For maximum en g ine life, never ac-
celerate har d when the en g ine is
col d !
EAU16673
Shiftin g
Shifting gears lets you control the
amount of engine power available for
starting off, accelerating, climbing hills,
etc.
The gear positions are shown in the il-
lustration.
TIP
To shift the transmission into the neu-
tral position, press the shift pedal down
repeatedly until it reaches the end of its
travel, and then slightly raise it.
1. Shift pedal
2. Neutral position
1
N
2
3
4
5
6
1 2
U1WS2AE0.book Page 2 Monday, December 7, 2015 2:00 PM