ENGLISH
Keyboard Stand Assembly
F11/F01 Owner’s Manual
61
Keyboard Stand Assembly
The illustrations here are taken from the F11.
CAUTION
• Be careful not to confuse parts, and be sure to
install all parts in the correct direction. Please
assemble in accordance with the sequence given
below.
• Assembly should be carried out by at least two per-
sons.
• Be sure to use the correct screw size, as indicated
below. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing
assembly of each unit.
• To disassemble, reverse the assembly sequence
given below.
Remove the following parts from the package.
1
Insert the rear panel (center).
Position the rear panel (center) so that the holes
face away from the front (keyboard side). Then
insert the projections on the panel into the holes
on top of the unit, as shown in the illustration.
CAUTION
• When the rear panel (center) is inserted in the
main unit, do not apply pressure to the rear panel
(center) from the front or rear. Doing so may dam-
age the projections of the rear panel (center),
allowing it to fall or be damaged.
Have a Phillips-head (+) screwdriver ready.
Assembly Parts
6
×
45 mm long screws
×
4
1
6
×
14 mm short screws
×
12
2
Rear panel (left)
Rear panel (center)
Rear panel (right)
Main unit
AC power cord
keyboard stand stabilizers: 2 pieces
Included in the packing pads.
Preparing the rear panels
When the package is shipped from the factory, the
rear panels are secured to the wooden fixing pads
with screws. Before you can start assembling the
rear panels, you must first remove them from the
fixing pads.
Removing the panels:
Stack two packing pads (included in the packing
box with the rear panels) under the rear panels,
then remove the screws as shown in the illustra-
tions.
CAUTION
• Do not use screws fixing rear panels to assem-
ble the instrument.
Rear panel (center)
Rear panels (left, right)
Stack two packing pads.
Fixing pad
Содержание MODUS F10
Страница 75: ...F11 F01 Owner s Manual 75 MEMO ...