16
4. Release the mouse button. The node is relocated.
Swapping a Grayed-Out Node
If mLAN Graphic Patchbay displays both a grayed-out node (page 14) and a new node of the same
model that has not yet been connected to any node, you can swap nodes. After you swap nodes, the
connection settings for the grayed-out node will be applied to the new node. The grayed-out node will
be deleted. This saves you from patching nodes from scratch when you change an mLAN device or use a
different mLAN device of the same model in a new location.
• You can swap a grayed-out node and a new node only if both nodes are for
the same model.
• To swap the nodes, no input or output connectors of the new node should be
connected.
1. Move the pointer to the new node, then press and hold down the mouse button.
NOTE